Anthony Gallo Acoustics Ref 3 SA


  • 1.000,00 USD

  • Ürün Kodu: 2E0002



Output Power:2 x 160 watts RMS @ 8 ohms 
20Hz - 20kHz (stereo mode)

2 x 250 watts RMS @ 4 ohms 
20Hz - 20kHz (stereo mode)

450 watts RMS @ 8 ohms 
20Hz - 20kHz (mono mode)

650 watts RMS @ 4 ohms 
20Hz - 20kHz (mono mode)
Distortion:0.08% stereo, 0.1% mono 
(low-pass @ 100Hz, level and xover at max, EQ at 0dB) 

.01% stereo, 0.17% mono 
(full-range, level at max)
Input Sensitivity:130mV stereo, 110mV mono
Signal-to-Noise:93dB stereo, 83dB mono 
(low pass @ 100Hz, level and xover at max, EQ at 0dB) 

93 dB stereo, 75dB mono 
(full-range full-rated power @ 1kHz)
Load Impedance:2 ohms or greater in stereo mode /
4 ohms or greater in mono mode
Bass EQ:1W @ 35Hz (100Hz=0dB, level and xover at max, booster at 6dB)=6.2dB 

1W @ 35Hz (100Hz=0dB, level and xover at max, booster at -3dB)=-3.2dB
Frequency Response:15-200Hz low-pass (100Hz=0dB, level and xover at max, booster at 0dB) 

<10Hz - 28kHz full-range (100Hz=0dB, level and xover at max, booster at 0dB)
Crossover:40Hz low-pass, xover setting at minimum 

200Hz low-pass, xover setting at maximum
Power Handling:250 watts @ 4 ohms 
160watts @ 8 ohms (In Stereo) 
650 watts @ 4 ohms 
450 watts @ 8 ohms (Bridged to mono)
12 Volt Trigger:Tip = (+) Sleeve = (-)
Auto-on Sensitivity:5mV
Current Draw:9A stereo, 13.5A mono 
(level and xover at max, booster at 0dB)
Protection Circuitry:Short circuit, open circuit, RF burnout, over temp., speaker protection relays, Turn on/off transient protection, DC protection, and limiter circuitry
Temp. Protect:60°C +/-5
Cooling:A low noise fan is utilized to draw cool air through the chassis using front and rear vents. Do not block the vents.
Power Requirements:100 VAC 60Hz, 850VA 
100-120 VAC 50/60Hz, 850VA 
220-240 VAC 50/60Hz, 850VA
Dimensions:19"W x 3.81"H x 15.62"D
Weight:35 lbs
Connections:RCA inputs, 5-way binding posts

Yorum Yap

Yorum Yap

Not: HTML'e dönüştürülmez!
    Kötü           İyi